[DMCForum] Three brass screws (Please help, I broke my car)
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DMCForum] Three brass screws (Please help, I broke my car)



It started out innocently enough: I wanted to do a tune up. So I
bought plugs, wires cap & rotor from one of our DeLorean vendors and
replaced them tonight. In doing so, I bumped those brass idle screws a
little. Not much, maybe 1/8 to 1/4 turn at most, but I bumped the back
two. I tried to put them back as best as I could.

My car won't run now. Fires right up, starts to settle into idle and
dies. The brass screws had already been opened by the previous owner,
so at this point I decided to play with them. Tried closing them,
tried various open positions. Some let the car run for 3 seconds.
Others for 1 second.

Then I closed them back down and the rear one just sheared right off.
I didn't use force in tightening it, but it broke anyway. It's all the
way closed and I can't adjust it anymore. Can a machine shop drill it
out? What should I do?

Please help. I'm lost.

Notes:

- All fuel lines and plug wires are correct. I labeled and
triple-checked everything when I did the tune up.

- The car was getting too much fuel when I bought it, I think. It went
"blubBlubBlubBlub" when you let off the gas. I was hoping to fix this
with the tune up, but now that it doesn't stay running for more than 3
seconds...

-Ryan



Yahoo! Groups Sponsor
ADVERTISEMENT
click here


Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated