RE:Re: [DMCForum] Re: Hub Nut Torque?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE:Re: [DMCForum] Re: Hub Nut Torque?



My Torque wrench is rated to 150 lb-ft.
I have know idea what my impact gun can do.

-----Original Message-----
From: Andrei Cular [mailto:andreic@xxxxxxxxxxxxxxxxxx]
Sent: Sunday, April 11, 2004 9:37 AM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: [spam] Re: [DMCForum] Re: Hub Nut Torque?


Just a cause your gun is rated at 150lb doesn't mean squat when it come to
tightening, most guns are rated in reverse and fwd has a lower rating.  Have
you ever tried to remove a reverse thread with a cheaper gun?  It probably
wont come off nearly as easy as you would expect.  If your gun and
compressor are strong enough you need to use torque sticks, they are the
impact version of a torque wrench, which will make sure you don't over
tighten it.

You really need to get a torque wrench, even the old bent beam type to make
sure that the wheels are on properly.  Also make sure to recheck them after
a few miles, Jim Strickland almost lost his front wheel cause he didn't
check it.


Andrei


----- Original Message -----
From: "Scott Mueller" <scott.a.mueller@xxxxxxxxx>
To: <DMCForum@xxxxxxxxxxxxxxx>
Sent: Sunday, April 11, 2004 10:27 AM
Subject: RE: [DMCForum] Re: Hub Nut Torque?


Rich,

I picked up a set of metric impact sockets from Harbor Freight for $20 her
in town.

It included a 32mm socket.

My torque wrench goes to 150 lb-ft, so the front was easy.

I may hang 50 lbs on the end of a 5 foot cheater pipe to torque the back.

Scott



-----Original Message-----
From: cruznmd [mailto:racuti1@xxxxxxxxxxxx]
Sent: Saturday, April 10, 2004 8:34 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: [spam] [DMCForum] Re: Hub Nut Torque?


Those are the values that I have.

If I had to offer an educated guess, I'd say it's because the rear has much
heavier bearings and structure. It is also exposed to much greater forces
given that that's where the drive wheels are.

All I know for sure is that I spent $30.00 on a 32mm impact socket and I let
my impact gun do the talking for me.

--- In DMCForum@xxxxxxxxxxxxxxx, "Scott Mueller" <scott.a.mueller@xxxx>
wrote:
> Looking through my manuals I found that the Front Hub Nut should be
torqued
> to 145 lb-ft and the Rear Hub Nut 270 lb-ft.
>
> The nuts on both the front and the rear are 32mm.
>
> Why would the torque value differ?
>
> Do you know of any other reference for the hub nut torque value?
>
> Scott Mueller
> 002981
> RNDOLA
> DOC-UK 357 Magnum
> DOA


Yahoo! Groups Sponsor
ADVERTISEMENT
click here


Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN


Copyright 2006 ProjectVixen.com.  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive