[DMCForum] nut and bolt supplier to DMC...

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

I would love to have been the supplier to DMC on nuts and bolts.  I finished
removing everything on the front end today and I swear there was a bolt or
screw every inch along the way.

Speaking of which, every screw that goes into a rivnut along the driver's
side plastic rocker panel is spinning in the fiberglass.  Has anyone found a
good way to get these separated?  On some I can soak them in penetrant, then
grab the edge of the rivnut with vise grips and get the screw out.  Any
other suggestions?  What about repairing or replacing these?

Greg

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.