Re: [DMCForum] Torque question

["Andrei Cular" <acular@xxxxxxxxxxxxxxx>]

It was given to me by one of my professors who got it out of some old
automotive engineering hand book.  As soon as I find it I will scan a copy
get it up to you.



Andrei



----- Original Message ----- 
From: "Walter Coe" <Whalt@xxxxxxx>
To: <DMCForum@xxxxxxxxxxxxxxx>
Sent: Thursday, June 26, 2003 8:36 PM
Subject: Re: [DMCForum] Torque question


> > I have a handy little table somewhere that gives standard torques
based
on
> > bolt size, wet or dry, gasket type or non-gasket.
>
> Andrei, where can I get a copy of such a table?
>
> The exhaust manifold studs are 7mm x 1,0
>
> I have seen 3 kinds of gaskets: OEM one-piece, PJ Grady one-piece, and
Volvo
> 3-pieces per side.  I suppose that they would all compress at about the
same
> rate -- probably nothing special.
>
> Walt
>
>
>
> To unsubscribe from this group, send an email to:
> DMCForum-unsubscribe@xxxxxxxxxxxxxxx
>
>
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>
>



Yahoo! Groups Sponsor	 
 
<http://rd.yahoo.com/M=251812.3170658.4537139.1261774/D=egroupweb/S=170512
6215:HM/A=1564416/R=0/SIG=11ti81skc/*http://www.netflix.com/Default?mqso=6
0164797&partid=3170658> 	 
 
<http://us.adserver.yahoo.com/l?M=251812.3170658.4537139.1261774/D=egroupm
ail/S=:HM/A=1564416/rand=301789012> 	

To unsubscribe from this group, send an email to:
DMCForum-unsubscribe@xxxxxxxxxxxxxxx



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> .

<<attachment: winmail.dat>>