Re: [DML] Gear Teeth Question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Gear Teeth Question

Speedometer magnet is set up for clockwise rotation. You'd need an
intermediate gear to change cable rotation.

Otherwise it "could" be done. A lot of engineering however. You'd
probably need to swap spindles (I doubt the passenger side is hollow).
Cable would be longer, but no longer than a full size domestic. Some
of the bends might get you into trouble though (unless you mounted the
angle drive upside down on the passenger wheel and ran the cable in a
giant U around the front of the car).

I really don't think all that work is the best solution. If screw
gears are directional, perhaps Houston could make their next angle
drive backwards, then add a third gear somewhere to get cable rotation
clockwise again (in a replacement Lambda box perhaps?).

Bill Robertson

>--- In dmcnews@xxxxxxxxxxxxxxx, Farrar Hudkins <fhudkins@...> wrote:
> So have you installed it on the right side? Or is that impossible?
> Farrar Hudkins
> #2613

To address comments privately to the moderating team, please address:

For more info on the list, tech articles, cars for sale see

To search the archives or view files, log in at 
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to:

Home Back to the Home of PROJECT VIXEN

Copyright 2006  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive