RE: [DML] Bypass? No...I think my car need therapy!

["John Hervey" <john@xxxx>]

Kevin, Typical loose connections at the inertia switch. If the plastic plug
on the bottom over heats the plastic connector part will swell and reform
it's self and the next time you plug it in you think it makes contact but it
won't. Clean the excess plastic off the connector that looks deformed if
any, make sure the metal contacts are tight, not just the plastic part, you
might have to pinch the metal connector a bit and try it again. If the pump
is drawing to much current, the connector will over heat again a possible
loose connection again. If it keeps happening, remove the plastic cover from
around the female pins and plug it in that way. Pump may have to be
replaced.
John Hervey
www.specialTauto.com

-----Original Message-----
From: Kevin Abato [mailto:delorean@xxxx]
Sent: Monday, September 22, 2003 5:50 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: [DML] Bypass? No...I think my car need therapy!


> This is REALLY strange! 3 times in the past few months, my car has
> refused to start. See what you think...

[quote trimmed by moderator]