Thanks Joe, I tested the current being drawn by the high-beams and it was 16A. I cleaned up the connectors and obviously the new fuse made a big difference (clean spades) If it happenns again, I'll be taking your advice Best Wishes Martin #1458 www.delorean.co.uk DMC Joe wrote: > This is a common problem and requires that a heavy duty in-line fuse holder > be installed to substitute for the fuse block fuse holder. If not replaced > the same fuse will continue to melt. If the problem is not corrected the > damaged fuse contacts will cause adjoining fuse contacts to overheat and > melt. To reduce heat build up in the fuse block do not install the black > fuse block cover.