[DMCForum] Re: Fixed at last....

["cruznmd" <racuti1@xxxxxxxxxxxx>]

Well...I did attempt to measure the resistance of the old and new 
wires.

This is where I'm confused and I'm trying to read up on it:

The old wire read 1,361 ohms. The new wire read much much higher (I 
forget right now)...something like 61k ohms...it was nearly off the 
scale. 

I thought -less- resistance was better? John Hervey sells 8mm, 350 
ohm/ft hand made wires. S'plain this one to me?

Rich A.
#5335

--- In DMCForum@xxxxxxxxxxxxxxx, "checksix3" <jetjock11@xxxx> wrote:
>  
> Congrats Rich. Yep, it usually is something simply. Next time don't 
> be pullin on anything but the boot when you handle dem wires ;)
> 
> Still, I'd like to see the failure mode to be sure. Too bad you 
don't 
> have a megger or a high voltage lead tester like they use for 
piston 
> airplanes...you could autospy that bugger just for grins.
> 
> Feel free to ask if you need help with the A/C thing, a good place 
to 
> start is with the websites mentioned below or the Hayes book. Walt 
> can also give you the scoop.

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.